BRASS HANDLE END CAPS BRASS END CAPS

Made to fit our standard trunk handles, 1.25" wide, either with or without slots.  These should be used with handles that have slots in them in order to allow the handle to slide back and forth in the bracket, which allows the handle to lay flat against the side of the trunk when not in use. 

HANDLE BRACKETS OR LOOPS WITH PINS

  brass finish, with pins (also available in antique brass finish - see below)

These brass-finish brackets fit over slotted handles like the ones shown above.  Takes four nails to attach each loop, so you need a total of 16 nails to do one trunk.  Note that the handles don't need to be nailed to the trunk if you use these loops, the pins under the loops hold the handles in place, and the slots allow the handle to lay flat against the trunk when not in use.  Slick.

Same Brackets - Antique Brass Finish These fit in a little better on old trunks.

Set of 4 Antique Brass Brackets with Pins

Handle Loop Brackets with No Pins

These babies fit over wide-end trunk handles like our TH-02 handles.  Total of sixteen nails required to attach four loops to a trunk. The handles themselves do not need to be nailed to the trunk; the loop holds the handle in place.  The handles can move within the loop, so they lay flat against the trunk when not being gripped.  These are brass-plated steel, available in either bright brass or antique brass finish. 

These are smaller loops, often used on doll trunks or smaller boxes.  They'll accept a handle that is no wider than 7/8" and no thicker than 3/8".  Brass finish, but not too terribly shiny.  Attach with nails only because if you use screws strange voodoo things may happen to your trunk.